• State TI Thinks Resolved
  • Locked Locked
  • Replies 5 replies
  • Answers 1 answer
  • Subscribers 22 subscribers
  • Views 252 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

CDCE62002EVM: EVM Software getting Crash again and again both rev. E and F

BALVAN SINGH
Prodigy 130 points
Part Number: CDCE62002EVM
Other Parts Discussed in Thread: CDCE62005, CDCE62002

Hi Ti Team

I have downloaded 

CDCE62005 EVM Control Software Installer both version E and F. When I am importing my previous ini file in SPI debug and when i tried to change and save then it keeps loading. The page shows it is not responding. PFB image for your refernce.

I am using windows 10.

  • 0
    TI__Mastermind 20900 points

    Hello Balvan,

    i am not able to reproduce that.

    Have you tried to uninstall both versions and only reinstall version F(1.4.8)?

    Do you have the same behavior if you use "File -> Save as..." or only from the SPI debug interface?

    Does this happen with other ini files as well? (there is one here: C:\Program Files (x86)\Texas Instruments Inc\CDCE62005)

    Could you please share the ini file?

    regards,

    Julian

  • 0 in reply to Julian Hagedorn
    Prodigy 130 points

    Hi Julian.

    Sorry for the late response.

    I am not able to attach ini file here.

    Can you please share your email id so i can mail u.

    I have uninstall both version E nd F. and install 1.4.8 still getting crash issue.

  • 0 in reply to BALVAN SINGH
    TI__Genius 10095 points

    Hello Balvan,

    I'll reach out to you, please send it to me and I'll take a look at what might be causing this issue.

  • 0 in reply to Aaron Black
    TI__Genius 10095 points

    Hello Balvan,

    Please note that CDCE62002 software is also available - I see you are utilizing CDCE62005 version E and F. Please advise as this might be your issue - trying to load in CDCE62002 settings into CDCE62005.

  • 0 in reply to Aaron Black
    TI__Genius 10095 points

    Hello Balvan,

    I've tested the .ini file shared with me and I was able to load in the settings. The settings look fine.

    You said this file was from a "previous ini file in SPI debug", were you individually programming the device registers before?