CDCLVD110A: Setting for output disabled when power on

Hello Shota,

Could you tell me what exactly the customer did already to try to disable the outputs? I have found this snippet (below) in the first page of the datasheet; therefore, make sure EN = 1 and not EN = 0. Also, please refer to p. 13, section 8.5 of the data sheet for more information on how to program this device (also included below)

Section 8.5

Hope this helps!

Good luck,

Andrea

Hi Andrea,

The customer was able to disable output with EN=1 by programing the register. He just would like to know output state(enabled or disabled) with EN=1 immediately after power-on(before programming the register).

Best regards,

Shota Mago

Hi Shota,

I would need some time to check that for you. During the power up, outputs should be following the CLKin if its present but currently I am not sure how the disabling would take into affect. I will get back with details after discussing this with design team.

Best,

Asim

Hi Asim,

Thanks for checking. Please close this thread.

Regards,

Shota Mago