Part Number: LMK1D2102
Tool/software:
Hello,
1) I will have a CMOS clock input signal from a SMA connector connecting to pin IN0+, should I float pin IN0- ?
2) I only use the OUT0 LVDS output and other 3 outputs are unused, should I float EN pin?
thank you
Hello Hien,
1. Follow topology below. If using SE input - unused intrapair must be biased to VDD/2.
2. That's fine. 
All outputs will be enabled in this case though.
If set to '1' only bank 1 outputs will be enabled.
Unused outputs can be left float or terminated. 
\
Best regards,
Vicente
