CDC913 programming EVM WIN7 driver and SW

Yu-Ning Lee

Other Parts Discussed in Thread: CLOCKPRO

I have issues intalling/running CLOCKPro SW and driver on WIN7.

In WIN7 32-bit, I can install the SW and the driver, but it does not find the EVM.

In WIN7 64-bit, the driver does not even install. Do you have WIN7 supported version of the SW and the driver?

0 Leandro_z over 13 years ago

Hi Yoon

thanks for your interest in our device. I will be check with our software programmer and come back to you by tomorrow.

Best regards,

Leandro

0 Leandro_z over 13 years ago in reply to Leandro_z

Hi Yoon,

I guess you are using the version available on the Website, am I right?

We are currently finalizing a new ClockPro version working in Win7 32b/64b environment. As soon as we finish we will post it on the TI website.

Best regards,

Leandro

0 Carlos Casanova over 13 years ago in reply to Leandro_z

Hello,

Any new notice about Win7 64 bits version?

Thanks in advance

Clock & timing forum