LMK03200 voltage and temperature derating

Sundar Rajan

Other Parts Discussed in Thread: LMK03200

Hi - I would like to understand the sensitivity to voltage and temperature . I was looking through the datasheets (for the parts we are considering), and did not see this. It would be fine to get this information from the simulator (is this possible?) or from characterization data under typical conditions.

I am looking for something similar to:

This was clipped from page 17 of: http://www.ti.com/lit/ds/symlink/lmk00301.pdf

I am hoping to get the above curves for voltage and temperature for the LMK03200.

over 12 years ago

0 Timothy T over 12 years ago

TI__Mastermind 28550 points

Hello,

Min/maxes are listed in the datasheet.

In general, increase in temperature increases propagation time through LMK03200 and increase in supply voltage decreases propagation time through LMK03200.

Hopefully this helps.

73,

Timothy

0 Sundar Rajan over 12 years ago in reply to Timothy T

Prodigy 20 points

HI - thanks. Yes I understand the general behavior. What I am looking for is a specification/derating curve. This could come from simulation or characterization data. An example curve (from the TI data sheet!) is shown in the original email.

Clock & timing

Clock & timing forum

LMK03200 voltage and temperature derating