LMK03200 VCO-divider at Clock design tool

Toshi

Other Parts Discussed in Thread: LMK03200, LMK03000I cannot find a VCO devider block of LMH03200 in the Clock Design tool. (Other LMK03xxx has a "VCO devider" in the setup diagram of Clock Design tool.) If this is a bug of the software, is it possible to update soon ?

over 12 years ago

0 Timothy T over 12 years ago

TI__Mastermind 28550 points

Hello,

LMK03200 does have a VCO divider block which can be bypassed. The configuration shown in the clock design tool has the VCO divider bypassed.

If you would like to use LMK03200 with VCO divider block (necessary if using 0-delay), then please use simulation with LMK03000. The simulation results for LMK03000 can substitute for LMK03200 when using VCO divider.

73,

Timothy

0 Toshi over 12 years ago in reply to Timothy T

Expert 1780 points

Timothy-san, thank you very much for your support. I'll try to ask customer to use LMK03000.

Clock & timing

Clock & timing forum

LMK03200 VCO-divider at Clock design tool