CDCE72010 Clock Buffer disable

Takumi Suzuki1

Mastermind 8610 points

Hi,

I would like to ask you a question about the register setting to disable "Universal output Buffer".

To disable the buffer, I should set the following value to the register(red). Is this correct?

If there is another way to disable, please let me know.

And in this case, all output buffers are in "3-state" and "low power mode", correct?

Thank you for your support.

Best Regards,

over 10 years ago

0 Arvind Sridhar over 10 years ago

TI__Mastermind 24205 points

Hi Takumi San,

Disabling the divider should also disable the output (Register 6 SPI Mode, EN6DIV = 0). The other way to disable the output is to set the OUTBUFxCD2LX/Y bits (CD Mode, Register 6) to '10' with CD2 Low or set the OUTBUFxCD2HX/Y bits (CD Mode, Register 6) to '10' with CD2 High. I believe the outputs will be tri-stated when disabled.

Regards

Arvind Sridhar

0 Takumi Suzuki1 over 10 years ago in reply to Arvind Sridhar

Mastermind 8610 points

Hi Arvind-san,

Thank you very much for your reply!

I understood well.

Regards,

Clock & timing

Clock & timing forum

CDCE72010 Clock Buffer disable