CDCE62002EVM

Alex Stuhl

Other Parts Discussed in Thread: CDCE62002

I have clear PC screen EVM Software 1.2.1 right frequency. All lamps are ON (EVM power, USB status, SPI Bus Status, Lock).

CDCE62002_2016_01_28.iniHowever, on EVM D33 PLL Lock is OFF. I see signals on SMA conn J12 and J22 up to 8V p-p 37-60MHz.

I'm attached ini file

Thanks

over 8 years ago

0 Madhu Balasubramanian over 8 years ago

TI__Expert 4400 points

What are the desired output frequencies and what input frequency do you want to use? Is it crystal input or external input and what level? I can generate an .ini file and send over. The file you attached shows a 30.72MHz input but the settings don't quite make sense.

0 Alex Stuhl over 8 years ago in reply to Madhu Balasubramanian

Prodigy 30 points

We used on-board crystal 30.72MHz. Problem is the PC screen and EVM not match. We can't go further.

0 Madhu Balasubramanian over 8 years ago in reply to Alex Stuhl

TI__Expert 4400 points

You can bypass on-board crystal and use an external reference at a desired frequency. What are the output frequencies you desire? Do you have any external reference that you can provide? Or you can swap out the on-board 30.72MHz crystal to another crystal with the desired frequency.

Because of the holidays, TI E2E™ design support forum responses will be delayed from Dec. 25 through Jan. 2. Thank you for your patience.

Clock & timing

Clock & timing forum

CDCE62002EVM