Balun with LMX2592

ACGUY

Hi,

Please give us advice.
Our customer is going to adopt the LMX2592.
They want to convert the 4G-6G output from differential to single end.
LTC has described the balun information to datasheet. (exp cds.linear.com/.../6946fb.pdf)
If you know the recommended balun, could you let us know it ?

Best regards,
Nagai,

over 9 years ago

0 Julian Di Matteo over 9 years ago

TI__Expert 4085 points

Hi Nagai,

Thank you for your interest in our products. We received your question and will be answering it as soon as possible. We appreciate your patience.

Regards,
Julian

0 ACGUY over 9 years ago in reply to Julian Di Matteo

Guru 11170 points

Hi Julian,

Thank you for your cooperation.
If you could answer by 8th this week, it would be very helpful.

Thanks,
Nagai

0 Dean Banerjee over 9 years ago

TI__Mastermind 28001 points

Nagai,
We have done no characterization with a balun on this device and all our single-ended measurements have been done by simply looking at one output and terminating the other side with 50 ohm, so unfortunately we have no balun to recommend. I was unable to open the attached link.

Regards,
Dean

Clock & timing

Clock & timing forum

Balun with LMX2592