how to used the Codelaoder software in Winodws 7 with 64 bits?

Hi Zhang,

Would you please uninstall the codeloader. Download and install the latest version from ti.com? maybe you can also try change your PC language to English and try again.

Hi, engieer,

    I have dowload the lastest version of codeloader from ti  and uninstall theold version codeloader. but the software is dosen't work. I have test in the windows xp with 32bits ,and the software work normally. can you have some other methods?

Hi Zhang,

Then please try search "codeloader" in e2e, see if you can find further suggestions to overcome this issue.
I don't have good answer to you, I am also using 64-bit Win7 but never have any problem at all.

Dear engieer,

   I used the LPT1 interface, and Do you use the "USB" interface? The following picture is the configuration of the port setup.

Dear engieer,

    I use the PCI/PCIE-to-LPT card  in this case. Dose  Pins confifuration of LPT is different?

Hi Zhang,

Pin Configuration should remain unchanged but the LPT Port address may be different. However, I have no idea what will be new LPT address.

Dear engieer,

     I  have checked the LPT new address and its value is D010. However, when the port address set D010, the sodeloader dosen't work and appeared error "run time error '6' with overfolw ". I have tied several times and and found  that the biggest value of the port address is 7FFF. Do you have methods to solve this problem?

Dear engieer,

     Do you have methods to change the input address range of the LPT port of the codeloader 4?

There are no current supported methods to enable changing the LPT address above a 15 bit number. Are there no setting for the LPT card to change the address to <= 7fff?

Otherwise it is probably simplest to get a USB2ANY.