• State TI Thinks Resolved
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 21 subscribers
  • Views 458 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

LMX2592: TICSpro setting for LMX2592

Toshihiro Watanabe
Genius 10235 points
Part Number: LMX2592

Hello,

Is it possible to make TICSpro setting file in below condition?

Fosc=120MHz, VCO freq = 5940MHz, RFoutA freq = 5940MHz

We are trying to reduce error rate of communication but it didn't reach the target. It seems fractional spur may be relating.

We would like to start the configuration for better phase noise and lower spur but I don't have a knowledge to do it.

Best regards,

Toshihiro Watanbae

  • 0
    TI__Guru** 108650 points
    Hi Watanabe-san,

    Yes, this is possible. With this configuration, I expect there might be spurs at 15MHz, 30MHz offset. Usually the spurs levels are small because they are far away from the carrier and they will be attenuated by the loop filter.