• State Resolved
  • Locked Locked
  • Replies 2 replies
  • Subscribers 21 subscribers
  • Views 374 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

CDCI6214: Pre-Configured Page 0 of EEPROM in the datasheet rev.C

Takahiro Saito
Expert 5465 points
Part Number: CDCI6214


Hi team,

In the datasheet rev.C(SNAS734C) , Fig.32 and Fig.33 is the same setup. Is it typo?

I think the pre-configured EEPROM page 0 and 1 should be different configuration according to Table.11 and the last version datasheet. 

Regards,

Saito

  • 0
    TI__Genius 16845 points
    Hi Saito-san,

    Yes, it is a typo. Thank you for finding it.
    It will be fixed in the next datasheet revision.

    Kind regards,
    Lane
  • 0 in reply to Lane Boyd
    TI__Expert 5465 points
    Thank you for considering to update the datasheet.
    Also, if we use the default CDCI6214, the typical application in Figure.90 shouldn't support the I2C communication because the EEPROMSEL is pulled down. But, I can see the I2C line in the figure. It's confusing. I'm appreciate if you could consider to change the EEPROMSEL pin to pull-up in Figure.90.

    Regards,
    Saito