CDCLVC1310: about CDCLVC1310 input bias

Vera Mao

Part Number: CDCLVC1310

hi dear supporting team,

is it ok to operate CDCLVC1310 with below circuit? the driver side is 1.8V, CDCLVC1310 has 3.3V power supply, and input without bias(i.e.no bias circuit like the one in the red circle), and has bias at negative side. tks！

over 7 years ago

0 Lane Boyd over 7 years ago

TI__Genius 16845 points

This configuration does not meet the datasheet spec for minimum VIH of 2V. Consider using a 3.3V LVCMOS input.

Kind regards,
Lane

0 Vera Mao over 7 years ago in reply to Lane Boyd

TI__Expert 5065 points

Hi Lane,

Thank you for the reply!

For the voltage level issue I double checked with BU before, since there is another spec on differential input which allowed 1.3V Vid , and the chip does not know whether it is single ended input or differential, so it should be ok to have 1.8V drive. Could you pls help double check.

And if the level is ok, then is it ok to have no bias at positive side? Tks!

0 Lane Boyd over 7 years ago in reply to Vera Mao

TI__Genius 16845 points

Hi Vera,

You can use it with 1.8V amplitude and no bias resistors on the positive side

Kind regards,
Lane

Clock & timing

Clock & timing forum

CDCLVC1310: about CDCLVC1310 input bias