CDCE706 clock init.

Ken Drewlo

Working with demo board CDCE906-706 clock distribution part, how do I get the on board to load my setup when I cycle the power?

over 13 years ago

0 Julian Hagedorn over 13 years ago

TI__Mastermind 20900 points

Hello Ken,

to program the device you have to connect it with a cable to the parallel port of your PC. With the s/w TI Pro Clock you can communicate with the device.

If you need to load a programming during startup, than you can choose the option to store your settings into the EEPROM. The settings stored in the EEPROM will reload at every power up.

You can find further information in the userguide.

Regards,

Julian

0 Ken Drewlo over 13 years ago in reply to Julian Hagedorn

Prodigy 50 points

Julian

Thank you, you are correct, I had to change the chip on the demo board and away it went.

Ken

Clock & timing

Clock & timing forum

CDCE706 clock init.