AFE4900: TIDA-01850

Hello,

If this board is sent to you by TI representative, it would be already flashed board.

If you have built the board on your own using the Gerber files, you need to flash the board with Tx firmware.

The CC2640R2F board need not be programmed or flashed with the RX firmware.

Regards,

Sanjay R. Pithadia

Hi Sanjay

               Thank you for your reply.

                But i flashed the TIDA_FIRMWARE_TX to TIDA-01580 Board.

                Then i open labview .exe application. The launcher CC2640R2 is not connect with this application. i attached below kindly verify it.

Hi,

From the screenshot, it seems that the Launchpad is not connected. Is your Launchpad connected properly?

After flashing the TIDA-01580 board, have you put back the jumpers on the Launchpad?

Also, please check if the .out file is located TIDA-01580_firmware_rx\FlashROM_Stack_Library folder.

Regards,

Sanjay R. Pithadia

Hi sanjay,

               i did some work on launcher pad like completely erase the flash memory by using uniflash tool and flashing the TIDA-01580_firmware_rx and for TIDA-01580 sensor board flashed TIDA-01580_firmware_tx.

               Then i connected to the labview application software. same error is generated.

Hi,

One thing you can check is that all softwares are installed with the suggested versions.