Part Number: TSW1400EVM
Default ADC3221EVM setting works with TSW1400, however, when I change ADC3221 to use 1-wire mode, this "frame clock error" pops up.
Is only default setting supported by TSW1400?
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Part Number: TSW1400EVM
Default ADC3221EVM setting works with TSW1400, however, when I change ADC3221 to use 1-wire mode, this "frame clock error" pops up.
Is only default setting supported by TSW1400?
Hi Yuan,
I set this up in the lab and saw the same error. I am checking with our design team and I will get back to you soon.
Regards, Amy
Hi Yuan,
To provide you an update, we are still checking into this. We are suspecting it is an issue with the firmware, so we are checking into that.
I will provide you an update either tomorrow or early next week. Thank you for your patience.
Regards, Amy
Hi Yuan,
Please try the following .ini file. I tested it out and I saw a good capture in 1w mode.
Regards, Amy
Additionally, ensure that you set register 0x05 to 0x01 to configure the part in 1w mode.