Dear Madam or Sir,
I am planning to use the DAC12DL3200 on a new hardware design.
To ease pcb routing and obtain good integrity performance, I would like to route “directly” the signals from the DAC VOUTA+- and from to the DAC VOUTB+- to their respective balun.
For one of the channels, it’s ok, but for the second the traces polarity has to be inverted.
So here is my question : is there a bit in a DAC12DL3200 register to enable the inverting of the analog output?
I searched the datasheet, the knowledge center and the forum without success.
Best regards.
