This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Tool/software:
Hello,
I try to configure the ADC3642 to work with the following configuration but I encounter some issues ...
- Output mode DDR
- Single ended clock
- 14bit data
- Sample rate 10MS/s
- SPI SCK : ~2.5MHz
Please find below the commands that I send to the chip through SPI:
NB: I have also tried to set the value 0x00 on register 0x000
I dont' have any clock in output on pin 25 (DCLK) and I don't understand why.
Is there something wrong with my configuration ?
I add below some pictures of the SPI signals I send.
Thanks in advance for your help and merry christmas !
Regards,
K. TOUTAIN
Hello,
I find out the issue... This was cause by the RESET signal that not correctly managed.
Sorry for the inconvenience.