TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    DAC8742HEVM: read/write the Low Level Configuration in GUI 0 Locked

    514 views
    1 reply
    Latest over 6 years ago
    by Garrett Satterfield
  • Suggested Answer

    DDC11XEVM-PDK: can not download DDC11XEVM-PDK Plugin Installation 0 Locked

    830 views
    10 replies
    Latest over 6 years ago
    by Praveen Aroul
  • Answered

    ADS1298: Violating tSCCS 0 Locked

    483 views
    3 replies
    Latest over 6 years ago
    by Ryan Andrews
  • Suggested Answer

    ADS1115-Q1: Difference between ADS1115QDGSRQ1 and ADS1115BQDGSRQ1 0 Locked

    793 views
    1 reply
    Latest over 6 years ago
    by Joseph Wu
  • Suggested Answer

    ADS1298ECGFE-PDK: Connecting the "Ground" Electrode to RLDOUT? [EMG] 0 Locked

    846 views
    1 reply
    Latest over 6 years ago
    by Alexander Smith
  • Not Answered

    DAC37J84 0 Locked

    530 views
    6 replies
    Latest over 6 years ago
    by Kang Hsia
  • Suggested Answer

    ADS1298: Need a reference circuit for EMG 0 Locked

    2017 views
    3 replies
    Latest over 6 years ago
    by Alexander Smith
  • Suggested Answer

    ADS1299-6: Channel1;3;5 are bad if I sample with higher as 500Hz. 0 Locked

    375 views
    4 replies
    Latest over 6 years ago
    by Stefan Erni
  • Suggested Answer

    TLA2024: Reference voltage 0 Locked

    401 views
    1 reply
    Latest over 6 years ago
    by Joseph Wu
  • Suggested Answer

    DAC1000 PC Software 0 Locked

    458 views
    3 replies
    Latest over 6 years ago
    by Annie Liu
  • Suggested Answer

    ADS1299: Using Internal Clock in ADS1299 GUI 0 Locked

    790 views
    3 replies
    Latest over 6 years ago
    by Ryan Andrews
  • Suggested Answer

    ADS114S08B: AINx Internal Clamping Diodes 0 Locked

    503 views
    1 reply
    Latest over 6 years ago
    by Bob Benjamin
  • Answered

    ADS1278-HT: Driver Op Amps 0 Locked

    651 views
    1 reply
    Latest over 6 years ago
    by Christian Yots
  • Suggested Answer

    ADS1298: Not able to Read differential voltage on ADS1298. 0 Locked

    902 views
    5 replies
    Latest over 6 years ago
    by Ryan Andrews
  • Not Answered

    ADS1296R: ADS1296RIZXGT Testing Faulty Parts 0 Locked

    547 views
    3 replies
    Latest over 6 years ago
    by Tom Hendrick
  • Suggested Answer

    ADS52J90: Driving ADS52J90 with single-ended signals 0 Locked

    1835 views
    27 replies
    Latest over 6 years ago
    by Nikolai Orlov
  • Suggested Answer

    ADS1271: Filter coefficients 0 Locked

    549 views
    2 replies
    Latest over 6 years ago
    by Keith Nicholas
  • Answered

    ADC32RF45EVM: Example code for interfacing with Xilinx ZCU102 or VCU118 FPGA boards? 0 Locked

    1015 views
    1 reply
    Latest over 6 years ago
    by jim s
  • Answered

    ADS1274: High speed mode 0 Locked

    409 views
    1 reply
    Latest over 6 years ago
    by Ryan Andrews
  • Answered

    ADC12D1600RF: Noise Power Ratio Specification 0 Locked

    260 views
    1 reply
    Latest over 6 years ago
    by Jim Brinkhurst1
<>