TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    ADS8684: ADS8684A 0 Locked

    698 views
    3 replies
    Latest over 6 years ago
    by Dale Li
  • Answered

    DAC38RF82: modes set-up, help needed 0 Locked

    567 views
    5 replies
    Latest over 6 years ago
    by Vincenzo Pizzolante
  • Not Answered

    ADC3424EVM: compatible with TSM1405EVM? 0 Locked

    436 views
    3 replies
    Latest over 6 years ago
    by marko kossatz
  • Suggested Answer

    ADS8681: Daisy chain in ads8681 0 Locked

    476 views
    2 replies
    Latest over 6 years ago
    by Dale Li
  • Answered

    ADS8681: Daisy chain in ads8681 0 Locked

    323 views
    1 reply
    Latest over 6 years ago
    by Dale Li
  • Suggested Answer

    AFE5818: HMC-DAQ-GUI ERROR 1003 0 Locked

    1413 views
    6 replies
    Latest over 6 years ago
    by Praveen Aroul
  • Answered

    BOOSTXL-ADS7841-Q1: Does the ADS7841-Q1 Evaluation Board mean to work only with EEPROM? 0 Locked

    632 views
    5 replies
    Latest over 6 years ago
    by Hau Tran
  • Suggested Answer

    ADS8363EVM: Pulling Register Information 0 Locked

    792 views
    6 replies
    Latest over 6 years ago
    by Tom Hendrick
  • Suggested Answer

    ADS7253: ADS7253 Write/Read issue 0 Locked

    700 views
    3 replies
    Latest over 6 years ago
    by Tom Hendrick
  • Suggested Answer

    ADS8681: Daisy chain in ads8681 0 Locked

    281 views
    1 reply
    Latest over 6 years ago
    by Tom Hendrick
  • Suggested Answer

    ADS8681: Daisy chain in ads8681 0 Locked

    573 views
    1 reply
    Latest over 6 years ago
    by Tom Hendrick
  • Answered

    DAC121S101QML-SP: Digital IO powered without power supply 0 Locked

    321 views
    5 replies
    Latest over 6 years ago
    by Kirby Kruckmeyer96848
  • Suggested Answer

    ADS124S08: Multiple analog type for every channel 0 Locked

    2047 views
    4 replies
    Latest over 6 years ago
    by Bob Benjamin
  • Suggested Answer

    DAC38RF82EVM: Using external sysref to reset NCO 0 Locked

    316 views
    1 reply
    Latest over 6 years ago
    by Ebenezer Dwobeng
  • Answered

    ADS131A02: Repeated Sample Values when Reading out from ADC 0 Locked

    414 views
    2 replies
    Latest over 6 years ago
    by Ajith Peter
  • Answered

    [FAQ] ADS129x: I'm having trouble communicating with my ADS129x device via SPI. What debug steps I should try? 0 Locked

    4657 views
    1 reply
    Latest over 6 years ago
    by Alexander Smith
  • Answered

    [FAQ] What documentation is available for the MMB0? 0 Locked

    4826 views
    1 reply
    Latest over 6 years ago
    by Alexander Smith
  • Suggested Answer

    ADS1281: How to calibrate ads1281? 0 Locked

    985 views
    5 replies
    Latest over 6 years ago
    by Bob Benjamin
  • Suggested Answer

    DAC1282: DAC1282 not working 0 Locked

    524 views
    1 reply
    Latest over 6 years ago
    by Bob Benjamin
  • Answered

    [FAQ] ADS129x: How do I verify that my ADS129x device is still functional? 0 Locked

    5391 views
    1 reply
    Latest over 6 years ago
    by Alexander Smith
<>