TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    DAC8734: How to treat the GPIO when not used? 0 Locked

    262 views
    1 reply
    Latest over 7 years ago
    by Kevin Duke
  • Suggested Answer

    DAC38J82: Is there an example of DAC38J82? 0 Locked

    246 views
    1 reply
    Latest over 7 years ago
    by jim s
  • Suggested Answer

    TSW14J56EVM: HSDC Pro Automation DLL 0 Locked

    1887 views
    12 replies
    Latest over 7 years ago
    by Brian Kincaid
  • Answered

    ADS124S08: ADS124S08 with 4x 3wire RTD input 0 Locked

    2126 views
    6 replies
    Latest over 7 years ago
    by Manu Abraham
  • Answered

    TLV2553: Delay time between falling edge of I/O clock and falling edge of EOC 0 Locked

    335 views
    1 reply
    Latest over 7 years ago
    by Sandeep Kasargod
  • Answered

    DAC161S997: DAC161S997 Grounding and EVM Component Question 0 Locked

    1306 views
    7 replies
    Latest over 7 years ago
    by Raghuveer Kasaraneni
  • Answered

    DAC37J84: Ground separation for DAC37J84 0 Locked

    505 views
    2 replies
    Latest over 7 years ago
    by Kiran VG
  • Answered

    ADS8902B: What is the minimum input voltage changes is to be sensible 0 Locked

    1354 views
    8 replies
    Latest over 7 years ago
    by Venkatesh P17
  • Not Answered

    ADS8326: Do you know any cause of a phenomenon that a DOUT data range is not output? 0 Locked

    569 views
    4 replies
    Latest over 7 years ago
    by Kazuya Nakai59
  • Answered

    ADS1015-Q1: Weird read value 0 Locked

    699 views
    3 replies
    Latest over 7 years ago
    by Roberto Cristoi
  • Suggested Answer

    TLC2543: TLC2543 Errors (INL, DNL, Offset, Gain, Total) 0 Locked

    448 views
    1 reply
    Latest over 7 years ago
    by Keith Nicholas
  • Suggested Answer

    DAC8822: About the "settling time" of DAC8822 vs. AD5547 0 Locked

    1110 views
    3 replies
    Latest over 7 years ago
    by Iven Xu
  • Suggested Answer

    ADC12DJ2700: ADC12DJ2700 device questions 0 Locked

    430 views
    2 replies
    Latest over 7 years ago
    by Neeraj Gill
  • Suggested Answer

    ADS8904B: 24Bit SAR 0 Locked

    443 views
    1 reply
    Latest over 7 years ago
    by Cynthia
  • Answered

    FDC1004: how to enable read-out of 12-channels with FDC1004 0 Locked

    740 views
    4 replies
    Latest over 7 years ago
    by Alex Semeniuk
  • Answered

    FDC1004QEVM: GUI Samples per Second Issues 0 Locked

    509 views
    2 replies
    Latest over 7 years ago
    by Susan Lane
  • Not Answered

    ADS54J66: ADS54J66 won't sync with TSW14J56EVM 0 Locked

    5780 views
    34 replies
    Latest over 7 years ago
    by Justin Rhodes
  • Answered

    ADS1271: ADS1271B Voltage Reference Question 0 Locked

    684 views
    4 replies
    Latest over 7 years ago
    by Mark Hughes
  • Suggested Answer

    ADS1293: HOW TO USE THE ADS1293 IN STREAMING MODE?? 0 Locked

    874 views
    4 replies
    Latest over 7 years ago
    by Alexander Smith
  • Answered

    ADC34J43EVM: SPI communication to the ADC34J43 EVM 0 Locked

    481 views
    2 replies
    Latest over 7 years ago
    by dBrock
<>