TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    FDC2114EVM: Not able to measure capacitances of a standard 200nF capacitor 0 Locked

    281 views
    1 reply
    Latest over 7 years ago
    by Chris Oberhauser66
  • Suggested Answer

    ADS8638: Have not found correct setup to get Auto-scan mode operating 0 Locked

    446 views
    4 replies
    Latest over 7 years ago
    by Cynthia
  • Suggested Answer

    ADC12DJ3200EVM: need to purchase another FMC+ adapter from ADC12DJ3200EVM kit 0 Locked

    547 views
    5 replies
    Latest over 7 years ago
    by Daniel Curry
  • Answered

    DAC60508: DAC output does not work when divide factor is 1 0 Locked

    784 views
    3 replies
    Latest over 7 years ago
    by Uttam Sahu
  • Suggested Answer

    AFE4300: how to do Z and θ calibration ? 0 Locked

    879 views
    6 replies
    Latest over 7 years ago
    by Anand Udupa16
  • Answered

    TSW30H84EVM: HELP Arria V RF Development Kit Reference Design 0 Locked

    649 views
    2 replies
    Latest over 7 years ago
    by Sourabh Tapas
  • Suggested Answer

    AFE4300: Ro and Ri 0 Locked

    502 views
    3 replies
    Latest over 7 years ago
    by Prabin Yadav
  • Answered

    FDC1004: Best way to connect electrodes at the tank to the FDC1004 board 0 Locked

    733 views
    3 replies
    Latest over 7 years ago
    by Chris Oberhauser66
  • Answered

    DDC1128: Output Data Format from EVM 0 Locked

    547 views
    2 replies
    Latest over 7 years ago
    by Shinichi Inoue
  • Answered

    DDC1128EVM: output data from the EVM 0 Locked

    1454 views
    8 replies
    Latest over 7 years ago
    by Shinichi Inoue
  • Suggested Answer

    DAC7760: DAC7760 overheating issue 0 Locked

    2298 views
    11 replies
    Latest over 7 years ago
    by Garrett Satterfield
  • Answered

    ADS58J89EVM: Unable to connect TSW14J56 to ADS58J89 0 Locked

    936 views
    9 replies
    Latest over 7 years ago
    by Ebenezer Dwobeng
  • Answered

    LDC1612: LDC1612 Questions about Rp. 0 Locked

    317 views
    1 reply
    Latest over 7 years ago
    by Chris Oberhauser66
  • Answered

    TSW14J56EVM: Automation DLL 0 Locked

    539 views
    1 reply
    Latest over 7 years ago
    by Abdurrahman Elmaghbub
  • Answered

    DAC38J82EVM: DAC3XJ84 Firmware 0 Locked

    939 views
    7 replies
    Latest over 7 years ago
    by Abdurrahman Elmaghbub
  • Answered

    ADS54J40: ADS54J40 interleaving / offset correction how to freeze 0 Locked

    806 views
    4 replies
    Latest over 7 years ago
    by user5087407
  • Suggested Answer

    ADS1231 VS AD70/015Z 0 Locked

    685 views
    3 replies
    Latest over 7 years ago
    by Bob Benjamin
  • Answered

    ADS5400: ADS5400 EVM Software 0 Locked

    590 views
    3 replies
    Latest over 7 years ago
    by Yusuf%20Agoro
  • Suggested Answer

    ADS5407: What is the HTS and ECCN number for exporting purposes on this part. 0 Locked

    589 views
    2 replies
    Latest over 7 years ago
    by Brian Kincaid
  • Suggested Answer

    TPL0102-100: Please make a 1024 tap version of this. Competitors have one. 0 Locked

    267 views
    1 reply
    Latest over 7 years ago
    by Kevin Duke
<>