TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Discussion

    No data coming from Chests ADS1298 Locked

    373 views
    7 replies
    Latest over 13 years ago
    by Tom Hendrick
  • Answered

    ADS7825 digital output voltage level 0 Locked

    437 views
    1 reply
    Latest over 13 years ago
    by Tom Hendrick
  • Answered

    DAC7554 SPI Voltage Levels 0 Locked

    708 views
    2 replies
    Latest over 13 years ago
    by Tony Calabria
  • Discussion

    ADS5263 18 bit characterization Locked

    274 views
    0 replies
    Started over 13 years ago
    by chuck reed
  • Answered

    ADS1248 DAC limitation 0 Locked

    244 views
    1 reply
    Latest over 13 years ago
    by Luis Chioye
  • Answered

    Level shifting using the DAP signal conditioning board. 0 Locked

    362 views
    3 replies
    Latest over 13 years ago
    by Tom Hendrick
  • Answered

    ADS1271EVM-PDK Jumper J7 setting 0 Locked

    462 views
    4 replies
    Latest over 13 years ago
    by Yixi Song
  • Answered

    ADS1271EVM-PDK's digital supply voltage setting 0 Locked

    322 views
    1 reply
    Latest over 13 years ago
    by Tom Hendrick
  • Answered

    About ADS1271EVM-PDK's MMB0 Board jumpers setting 0 Locked

    510 views
    3 replies
    Latest over 13 years ago
    by Yixi Song
  • Answered

    about J13 setting on MMB0: ADS1271EVM-PDK voltage supply(2) 0 Locked

    444 views
    5 replies
    Latest over 13 years ago
    by Tom Hendrick
  • Answered

    About the ADS1271EVM-PDK power supply with buffer amplifiers 0 Locked

    314 views
    1 reply
    Latest over 13 years ago
    by Tom Hendrick
  • Answered

    About the analog input signal for ADS1271EVM-PDK 0 Locked

    333 views
    1 reply
    Latest over 13 years ago
    by Tom Hendrick
  • Answered

    ADS8472EVM parallel data output 0 Locked

    490 views
    3 replies
    Latest over 13 years ago
    by Tom Hendrick
  • Answered

    On ADS1247: Does ADC input have to be bipolar to use full range? I'd like to read positive numbers only but use full ADC range. 0 Locked

    715 views
    5 replies
    Latest over 13 years ago
    by Bob Benjamin
  • Not Answered

    looking for vga analog to digital converter 0 Locked

    367 views
    1 reply
    Latest over 13 years ago
    by Matt Guibord
  • Answered

    ADS1298 level 0 Locked

    484 views
    5 replies
    Latest over 13 years ago
    by Tom Hendrick
  • Answered

    LMP90080, LMP90100 and DRDYB signal 0 Locked

    579 views
    5 replies
    Latest over 13 years ago
    by Nicola
  • Answered

    TSM470R1B1M 0 Locked

    315 views
    3 replies
    Latest over 13 years ago
    by Max
  • Answered

    SM470R1B1M - power dissipation 0 Locked

    305 views
    2 replies
    Latest over 13 years ago
    by Max
  • Not Answered

    HKJ Thermal Resistance 0 Locked

    211 views
    2 replies
    Latest over 13 years ago
    by Max
<>