DLP230NP: Optical Data

Furkan Fehmi Sefiloglu

Part Number: DLP230NP

Hi Team,

Can you please check and advise with following request?

Within the scope of the study, an optical analysis setup must be set up.

We cannot open the attached file on the Texas Instrument site in Zemax 2013 (student version) and Ansys Speos optical design programs.

We need the optical data of this product that we can open in both programs. I request your support on the subject.

Thanks in advance

Best Regards

Furkan Sefiloglu

0 Vivek Thakur over 3 years ago

Hello Furkan,

Welcome to DLP forum and thank you for your interest in DLP technology.

We will check if there is any issue with opening the file Zemax. It will take time and try to get back to you end of the week.

Furkan Fehmi Sefiloglu said:
Ansys Speos optical design

We can not support your request for above system.

Thank you for your understanding.

regards,

Vivek

0 Vivek Thakur over 2 years ago in reply to Vivek Thakur

Hello Furkan,

You are using a very old version of Zemax. The data was created with later version. Please try opening with latest version of Zemax.

regards,

Vivek

DLP products forum