4 bit SPI interface

Jacky Hung

Other Parts Discussed in Thread: TXB0106

Hi Sir,

We got the request from customer, they would like to have the redriver for quad mode (4 bit) SPI interface... did we have any candidate for it?

They would like to evaluate the redriver for touch pad which with SPI interface.

Thanks,

over 4 years ago

0 Clemens Ladisch over 4 years ago

Guru 322800 points

Quad SPI typically uses bidrectional signals. For such a protocol, buffering is not possible without a separate direction signal.

Is there more information about that touch pad protocol?

0 Jacky Hung over 4 years ago in reply to Clemens Ladisch

Prodigy 10 points

We use Gen-Z connector for touch pad interface. And still need candidate for Quad SPI that uses bidrectional signals. Could you recommend product for it ?

0 Yuan Rao over 4 years ago in reply to Jacky Hung

TI__Intellectual 1150 points

Hi Jacky

The Quad SPI includes 4 bit data but the total bit count should be 6 including SS and SCLK.

Because SPI interface typically is bidirectional, TXB0106(auto bidirectional device) is recommended for its push-pull output and good signal integrity.

Thanks,

Yuan

0 Jacky Hung over 4 years ago in reply to Yuan Rao

Prodigy 10 points

Hi Yuan,

TXB0106 looks like bidirectional level-shifting. Could it be re-driver application ?

Thanks.

0 Clemens Ladisch over 4 years ago in reply to Jacky Hung

Guru 322800 points

The TXB has less drive strength at its outputs than it requires at its inputs (this is how it implements bidirectionality). So it cannot be used as a buffer/redriver.

0 Dylan Hubbard over 4 years ago in reply to Clemens Ladisch

TI__Mastermind 47275 points

Hey Jacky,

We don't have any device that can perform this function unfortunately.

Interface

Interface forum

4 bit SPI interface