Hi Expert,
Now the INH pin of TCAN1043-Q1 is linked to SBC wake pin, but we hope there is no high output from INH pin to wake up SBC.
Is there a method making the INH pin of TCAN1043-Q1 no output by software method? Thank you sincerely!
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi Expert,
Now the INH pin of TCAN1043-Q1 is linked to SBC wake pin, but we hope there is no high output from INH pin to wake up SBC.
Is there a method making the INH pin of TCAN1043-Q1 no output by software method? Thank you sincerely!
Hi Brody,
There is no way to change the behavior of the INH signal through software. This pin will always be high when the transceiver is in any active mode and will only be off (high-z) when the device is in sleep mode.
I'm not sure I understand the use case here. Can you elaborate on the implementation here and the desired behavior of the INH signal? A block diagram may help my understanding.
Regards,
Eric Schott