• State Resolved
  • Locked Locked
  • Replies 2 replies
  • Subscribers 32 subscribers
  • Views 93 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Original question:

TUSB320LAI: How to set up the TUSB320LAI to charge the iPAD.

TUSB320LAI: How to set up the TUSB320LAI?

Pakho
Prodigy 95 points
Part Number: TUSB320LAI
Other Parts Discussed in Thread: TUSB320,

Tool/software:

Hi TI team,

TUSB320 can work with 3V3 VDD input.

Now we want to support 5V/3A output. Regarding the datasheet, we increased the VDD to 5V. But now it doesn't work.

Please help check what's going on. The boot sequence is as follows.

  • 0
    Prodigy 95 points

    I2C communication is normal.

    I set the current advertisement to HIGH, the port mode to DRP_MODE, the port mode prefer to DRP_TRY_SRK, and the UFP accessory to UFP_DISABLE.

    But the CC pin output is not PWM.

  • +1 in reply to Pakho
    TI__Mastermind 24080 points

    Hi Pakho,

    1. How are you enabling the type-C VBUS? Typically this is done with a VBUS switch that is controlled by the TUSB320LAI ID pin. I see in your design that ID is No-connect. Make sure that the VBUS is only enabled after the CC negotiation is complete or it can cause issues.

    2. Can you show the CC1/2 and VBUS waveforms at the point of attachment?

    Pakho said:
    we increased the VDD to 5V. But now it doesn't work.

    Is the TUSB320 not able to establish a connection at all? Or is the issue that the CC pins PWM is not what you expect for TRY.SRC?

    Best,

    Shane