TUSB1044A: Could you please check if there are any issues with the schematic design?

Hi,

I will review the schematic and try to get back to you by tomorrow.

Hi,
Can you share a block diagram of the system this board will be plugged into?

The requirements of our project are as follows: A TYPE-C cable with a length of approximately 7 meters was used in the project. Concerned about signal attenuation, a signal enhancement adapter board was designed, and the TUSB1044 chip was selected on the board. The purpose is to enhance the transmission distance of TYPE-C by using the GPIO setting mode. Help determine the following two questions.

Q1: Can TUSB1044 meet our requirements?

Q2: Please help check if the connections in the schematic diagram are correct.

Hi,

the longest cable defined in the spec at 10Gbps is 1m. Will the redriver be placed in the cable? 

A 7m cable is too much loss for the TUSB1044 to compensate for.