OCTVO-3P-OSD62X: osd62-pm-brk

Meera Shah

Tool/software:

I am using OCTAVO's osd62 for my project development. From the README I came to know that board flashing can be done using SD card, but my custom board doesn't have SD card support. Is that any other techniques to flash this board?

over 1 year ago

0 Johnson John over 1 year ago

TI__Intellectual 2760 points

Hi Meera,

Which SDK are you planning to use for your project - Linux SDK or MCU+ SDK?

Regards,
Johnson

0 Meera Shah over 1 year ago in reply to Johnson John

Prodigy 90 points

I am planning to use Yocto image for MPU and SDK for MCU. Because I would like to modify in BSP so Linux SDK won't be helpful.

0 Johnson John over 1 year ago in reply to Meera Shah

TI__Intellectual 2760 points

Hi,

You could refer this similar query - https://e2e.ti.com/support/processors-group/processors/f/processors-forum/1484486/am62a7-there-are-no-sd-card-and-eth0-after-soc-how-should-i-flash-the-program-into-the-emmc

Let me know if this helps.

Regards,
Johnson

Interface

Interface forum

OCTVO-3P-OSD62X: osd62-pm-brk