RS485-FL-DPLX-EVM: STEP File or Dimensions for RS485-FL-DPLX-EVM

Ben Stainthorpe

Hi there,

Could you please provide a STEP file or alternatively board dimensions and mounting hole positioning information for this board please?

I see a cadence .brd file has already been shared in the forum for this part, however unfortunately I cannot access any software to convert this to STEP from my company's libraries.

Thanks,
Ben

1 month ago

0 Ethan White 1 month ago

TI__Intellectual 2670 points

Hi Ben,

Looking at the same schematic files that were posted to E2E that you weren't able to open I grabbed the location of the mounting holes for you (note the board is 4000 x 3000 mils or 4 x 3 inches):

(300, 300)

(300, 2700)

(3700, 2700)

(3760, 320)

All of the above measurements are in mils. According to the drill chart they are 125.0 +/- 2.0 mils in diameter and non-plated.

Hope that helps!

-Ethan White

0 Ben Stainthorpe 1 month ago in reply to Ethan White

Prodigy 20 points

Hi Ethan,

Thanks for that!

Would it be possible to also supply the STEP file for the board please?

No problems if not.

Thanks,

Ben

0 Ethan White 1 month ago in reply to Ben Stainthorpe

TI__Intellectual 2670 points

Unfortunately, a STEP file is not available right now.

-Ethan White

0 Ben Stainthorpe 1 month ago in reply to Ethan White

Prodigy 20 points

No probs, thanks!

Interface

Interface forum

RS485-FL-DPLX-EVM: STEP File or Dimensions for RS485-FL-DPLX-EVM