• State Resolved
  • Locked Locked
  • Replies 1 reply
  • Subscribers 32 subscribers
  • Views 557 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TPS2557 / current limit test

ACGUY
Guru 11170 points
Other Parts Discussed in Thread: TPS2557

Hi all,

Please let us know how to check the over-current about TPS2557.

Or,

Over-current test is done to all of the device?

When the normally operation, can us check the current-limit settings at after assembly?
For example, check the voltage of ILIM-port...

Please your advice.

Best regards,

Yoshitaka Nagai

  • 0
    TI__Mastermind 42795 points

    Yes, OC test is done on all devices in production test. You can refer to the test conditions in the datasheet electrical characteristics table for multiple ILIM resistor values.

    I've attached a short test procedure that we perform on an example EVM. This checks the current limit using a scope and current probe.HPA636B_Test.doc