DS90UB954-Q1: DS90UB954 schematic review

peiyq

Part Number: DS90UB954-Q1

Hi TI ,

we are design a Deserializersystem ,could you please review the DS90UB954 schematic ?we are transferring OV4689 using DS90UB954 with POC

thanks

peiyuanqing

over 7 years ago

0 Palaniappan Manickam over 7 years ago

TI__Genius 10475 points

Hello,
We have PCB guidelines in the DS90UB954 datasheet that you can refer to. If you have some specific questions after your review that are not confidential in nature to your schematics you can ask them here.
For sharing confidential information such as your actual schematics please contact your local TI contact person. If you do not have one, we can take it offline and someone can work with you to provide any assistance.

0 peiyq over 7 years ago in reply to Palaniappan Manickam

Expert 1400 points

Hi Quote

Thanks for your quickly reply, could you review the schematic online

B&R

peiyuanqingcamera.pdf

0 Steven(Shenzhen) Shi over 7 years ago in reply to peiyq

TI__Mastermind 30515 points

regarding the EVM design, please refer to TI's UB954 EVM design. In this public forum, in future the sch. is NOT recommended here. for your case, basically please note:
1. power supplies design: FB is recommended to isolate different power rail, please refer to EVM's refer design;
2. High speed diff. signal in R-/R+ pin: please check it is matching your design request? the unused pin channel can be floating. and the PoC circuit design follows up the EVM's refer? details on PoC design, please refer to 954 d/s or the link www.ti.com/fpd-link
3. control signal: please set it in the correct mode based on your system design, such as BIST, PASS, GPIO, VDD_SEL, IDS, Mode_sel etc., the unused GPIO pins can be floating directly.
4. for CMLout pins, please refer to EVM's design, which can be used for debug in future.

regards,
Steven

Interface

Interface forum

DS90UB954-Q1: DS90UB954 schematic review