DS90UB928Q-Q1: DS90UB928Q default setting file

Lin Hsian

Part Number: DS90UB928Q-Q1

Hi ,
Have any default setting fie(ex. .txt or excel file ) can provide.
Customer wants import the setting file to IC memory for default setting.

Warm Regards,
Lin

over 6 years ago

0 Casey McCrea over 6 years ago

TI__Guru** 103215 points

Hello Lin,

These devices do not have non-volatile memory for user configuration. They need to be programmed via I2C on each power up.

Best Regards,
Casey

0 Lin Hsian over 6 years ago in reply to Casey McCrea

Expert 1580 points

Hi Casey,

We wants eeprom setting file to set pin status, such as GPIO_REG, PDB pin....
By the way, could you please leave e-mail to easy communication through PM.

Warm Regards,
Lin

0 Casey McCrea over 6 years ago in reply to Lin Hsian

TI__Guru** 103215 points

Hello Lin,

I'm sorry but as I mentioned, these devices do not have the ability to load settings like those from EEPROM. They need to be written by an I2C master to the device after boot.

Best Regards,
Casey

0 Lin Hsian over 6 years ago in reply to Casey McCrea

Expert 1580 points

928 Register Setting1.pdfHi Casey,

As I mention the register setting as attached file.

Could you please check have any register setting that I misunderstand?

Warm Regards,

Lin

0 Casey McCrea over 6 years ago in reply to Lin Hsian

TI__Guru** 103215 points

Hello Lin,

I don't see any obvious problems but I don't have any knowledge of your system. It looks like almost all of the registers are default values anyways.

Best Regards,

Casey

Interface

Interface forum

DS90UB928Q-Q1: DS90UB928Q default setting file