• State TI Thinks Resolved
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 33 subscribers
  • Views 711 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

THVD1452: Could operate THVD1452 full-duplex device in half-duplex device

Gabriel Xu
Intellectual 2145 points
Part Number: THVD1452

Hi team

I have several questions about THVD1452 full-duplex RS485 device.

I wonder to know could I operate this device in half-duplex mode through tie bus A with bus B together and control RE/DE pin by MCU in the meantime?

What other things should we notice to apply a full-duplex device as a half-duplex device?

In datasheet THVD1452 is 50Mbps rated. I want to know are this mean we could actually use in 50Mbps communication rate?

  • 0
    TI__Guru 62920 points

    Hi Gabriel,

    Any full-duplex RS-485 transceiver that has DE/RE control signals can be used in a half-duplex fashion by tying the A and Y pins together and the B and Z pins together.

    Yes, the device is capable of operating at 50 Mbps.  You can see an example of the device functioning at this rate in Figure 39 of the datasheet.  Whether or not the whole application would work at this rate would depend not just on the transceiver but the maximum rate supported by the MCU/UART as well as the cabling and network topology.  To get a better idea of how cabling can impact signal integrity in RS-485 applications, you can reference this application note:

    http://www.ti.com/lit/an/slla431/slla431.pdf

    Please let us know if you have any further questions.

    Regards,
    Max