• State Resolved
  • Locked Locked
  • Replies 2 replies
  • Subscribers 34 subscribers
  • Views 361 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Original question:

TUSB4041I EEPROM load settings

TUSB4041I: Eeprom programming tool; reading register using custom software

marcus
Prodigy 25 points

Part Number: TUSB4041I

Hi TI-Team,

Could you please provide me the Windows software for accessing the configutation eeprom connected to a TUSB4041 - chip?

In addition I'd like to ask if it is possible to access the TUSB4041's registers from my software to get Information e.g. which ports are used.

Cheers
Marcus

  • 0
    TI__Guru 60870 points

    Hi Marcus,

    Accept my friend request and send me a note when you do and I can provide the utility.

    There is no tool to read back the registers of the hub over USB while it is in normal operation mode, but the USB descriptors reported by the hub will report the used / unused hubs.  You can check them by downloading a tool like USB Device Tree Viewer and checking the config descriptors.

    Regards,

    JMMN

  • 0 in reply to JMMN
    Prodigy 25 points

    Hi JMMN,

    Thank you for sending the downlink via PM.

    After manually installing then enclosed Driver (and ignoring the Windows warning that the driver is not suitable for the device ;) )  the tool started.

    Cheers
    Marcus