Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.

  • State Resolved
  • Locked Locked
  • Replies 1 reply
  • Subscribers 32 subscribers
  • Views 474 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

THVD1450: Noise protect issue

Nicky Lim
Genius 3195 points
Part Number: THVD1450

Hello,

There is some noise issue with  THVD1450.

-. Problem : When connect RS-485 device to this THVD1450, Noise is asserted.

-. Question : Can use bead instead of 10ohm resistor as described in datasheet as below?

-. RS-485 max data rate: 115.2kbps

 

 -. Bead Spec

Please let me get your answer.

Regards,

Nicky

  • 0
    TI__Mastermind 25705 points

    Nicky,

    Definitely you can use beads on the bus. The inductive response may help filter some noise. However I suggest you characterize the noise first, like common mode or differential, amplitude, frequency. If you have more information about the noise like waveform, I would like to take a look.

    Regards,

    Hao