Hi TI Team,
I am using the RS 485 protocol and the IC Part No- SN65HVD30D, I have some doubt-
Question -
I am referring the datasheet for using the Part No- SN65HVD30D in fullduplex mode, In datasheet page-1 , it is mentioned ie we can connect the two microcontroller with the help of RS485 .
In master side D-> Input and R-> Output, But in the diagram It show some different, Can you please check and revert me.
My Suggestion-
May be it is TYPO error , Please correct me if I am wrong.
Please provide your valuable feedback on this .
Thanks
Regards
Naresh
