Texas Instruments (TI) Isolation support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search isolation IC content or ask technical support questions on everything from digital isolators and isolated transceivers to transformer and isolated drivers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] What is ISO1228's current limit feature? What is IEC 61131-2 type 1, 2 and 3 inputs?

    Part Number: ISO1228 Tool/software: What is current limit feature? What is IEC 61131-2 type 1, 2 and 3 inputs?

  • [FAQ] Can ISO1228 Support Both Sink and Source Mode Operation at the Same Time?

    Part Number: ISO1228 Tool/software: Can ISO1228 Support Both Sink and Source Mode Operation at the Same Time?

  • [FAQ] Are there any suggestions from TI on how to comply with the "Safety Limiting Values"?

    Part Number: ISO7740 Tool/software: Ok I know what Safety Limiting Values are, now how do I comply with them? Are there any suggestions from TI on how to comply with the "Safety Limiting Values"?

  • [FAQ] ISO7740: Why are safety limiting values important?

    Part Number: ISO7740 Tool/software: Why are safety limiting values important?

  • [FAQ] ISO7740: What are safety-limiting values?

    Part Number: ISO7740 Tool/software: What are safety-limiting values?

  • [FAQ] What is sinking type and sourcing type inputs?

    What is sinking type and sourcing type inputs?

  • [FAQ] How to set sinking type or sourcing type in ISO1228?

    Other Parts Discussed in Thread: ISO1228 How to set sinking type or sourcing type in ISO1228?

  • [FAQ] What primary inductance value should I choose for my push-pull power supply design using SN650x devices?

    What primary inductance value should I choose for my push-pull power supply design using SN650x devices?

  • [FAQ] Whey are D1 and D2 pins of SN650x push-pull transformer driver shorted to GND?

    Other Parts Discussed in Thread: SN6505B , SN6505D , SN6501 , SN6505A Whey are D1 and D2 pins of SN650x push-pull transformer driver shorted to GND?

  • [FAQ] Can a digital signal be applied to digital isolator input when its respective VCC is 0V?

    Can a digital signal be applied to digital isolator input when its respective VCC is 0V?

View FAQ threads