TLK2711-SP: Power on Sequence when they use it in transmit only mode

Hello,

My customer has a question about TLK2711-SP.

[Q]

Please tell me the power on sequence when they use it in transmit only mode.

Is my understanding correct ?

<My understanding>

1. TLK2711-SP generates a power-on reset under the following conditions.
   • when it exceed the minimum valid voltage (2.375V)
   • valid TXCLK
   • ENABLE is High by the following one of ways
   • It is driven to high by external driver
   • It is high by internal pull-up when It is driven with High-Z by external driver 
2. LCKREFN is High by the following one of ways
   • It is driven to high by external driver
   • It is high by internal pull-up when It is driven with High-Z by external driver 
3. LOOPEN is High by the following way
   • It is driven to high by external driver
4. Wait for at least 1ms until internal power-on reset comple
5. Changes in Transmit only mode by reset the receiver

• LCKREFN is driven to Low by external driver

Best Regards,

Hiroshi Katsunaga