SN74LVC2G241: PSPICE simulation error- Divide by zero

Hi Vidhya,

I just downloaded and tested the model from TI.com and it appears to work correctly - could you try again and verify there wasn't a mistake in the .olb creation?

Hi Emrys,

can you share the .olb file that has worked for you?

Thanks,

Vidhya

Hi Vidhya,

I didn't use PSpice for TI to verify the model. I just checked that the .cir file is correct using two other simulators - TINA-TI and Qspice. Both worked fine, so I expect the SPICE netlist is correct.

ok. I am looking for .olb file to simulate in PSPICE.

Hi Malcolm,

With the suggested setting, there is still error.

PFA.

Thanks and Regards,

Vidhya

I had used generate part option in PSPICE for TI tool to convert .CIR to .OLB  

I see simulation error in PSPICE.

I tried uploading the .OLB file. it is not getting uploaded.

I had seen this video. Used generate part to convert .lib or .CIR to .OLB

Vidhya,

Did you add the part library to the simulation configuration like the video shows? Could you just send a picture of your schematic?

Best,

Malcolm

HI Malcolm,

PFA schematic. It is not matching datasheet.

Datasheet:

Thanks,

Vidhya

Hi Malcom,

If you refer to the schematic snap, there are 2 channels. The model shows only one channel and is not matching the datasheet.

Thanks,

Vidhya

Hi Malcolm,

For one channel, the Enable pin is active low and another channel it is active high.

Thanks,

Vidhya

Thanks Malcolm.