• State TI Thinks Resolved
  • Locked Locked
  • Replies 2 replies
  • Answers 1 answer
  • Subscribers 19 subscribers
  • Views 880 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

over and under shoot of SN74AHC1G125

HIRATA MITSUO
Intellectual 490 points
Other Parts Discussed in Thread: SN74AHC1G125

Hi

SN74AHC1G125 has overshooting and undershooting over absolute voltage.

(see attached file : overshoot is 0.8V(>0.5V), undershoot is -1.08V(<-0.5V))

Now I check how to mearure,.

However if this wave form is correct, I would like to know whether this over/undershoot is problem or not?

Best regards,

Mitsuo Hirata

  • 0
    TI__Mastermind 41310 points

    Mitsuo-san,

    I have moved your post into the product line forum.

  • 0 in reply to Britt Brooks - Online Design Tools
    TI__Guru 59450 points
    Hi Mitsuo San ,

    Abs max specification have the input and output abs max voltage which the pins can withstand , beyond which , there could be reliability concerns for the device . A small resistance on the input can help reduce the overshoots and undershoots to be below the abs max . It also helps in limiting the current into the device to be below the abs max spec .
    The output waveforms overshoots and undershoots really do not depend on the input waveforms as such . The high drive can be limited also be output damping resistors , having proper bypass caps close to Vcc pin.