TXS0108E: Push-pull and open drain structure setting

Randy Wang

Part Number: TXS0108E

Hi Team

TXS0108E can support push-pull and open drain output structure with different data rate, I'm wondering how to set open drain or push pull structure? I think default it's in push pull if I directly connect to load? thanks.

over 8 years ago

0 ShreyasRao over 8 years ago

TI__Guru 63060 points

Hi Randy,

There are no external setting or registers to be programmed to select the open drain vs push-pull mode.
As long as a valid input signal is present(OD or PP), the device automatically will translate the signal at the output port.
I have included this question into the FAQ as well which can be referred here below:
e2e.ti.com/.../3567.02-txs-devices

Logic

Logic forum

TXS0108E: Push-pull and open drain structure setting