RM57L843: MIBSPI RECEIVING SIGNAL INTERRUPT - EXAMPLE CODE

AJITH KUMAR

Part Number: RM57L843

Hi TI-Team,

Please provide the example code for mibspi whenever the signal received, the code should enter the interrupt.

And other question i have when continously receiving spi data.I need to get into the interrupt for specific data.Is it possible.And what are possible ways.

Thanks and Regards,

A. Ajith Kumar

over 2 years ago

0 jagadish gundavarapu over 2 years ago

TI__Guru 72956 points

Hi Ajith Kumar,

I started working on your issue and will provide you an update ASAP.

--
Thanks & regards,
Jagadish.

+1 jagadish gundavarapu over 2 years ago in reply to jagadish gundavarapu

TI__Guru 72956 points

Hi Ajith Kumar,

You can find mibSPI examples in below FAQ

(+) [FAQ] TMS570LC4357: Examples and Demos available for Hercules Controllers (E.g. TMS570x, RM57x and RM46x etc) - Arm-based microcontrollers forum - Arm-based microcontrollers - TI E2E support forums

If you want to generate the interrupt for single frame of transmission or reception, then you should configure the Transfer group length to 1.

AJITH KUMAR said:
And other question i have when continously receiving spi data.I need to get into the interrupt for specific data.Is it possible.And what are possible ways.

You can't automatically enter to the interrupt handler for specific data only. You have to verify the data every time after receiving data and should need to do necessary operation after you got specific data or else you can ignore the received data, you have to do this only.

--
Thanks & regards,
Jagadish.