• State
  • Locked Locked
  • Replies 3 replies
  • Subscribers 32 subscribers
  • Views 341 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Original question:

MSPM0L1305: Flashed the code does not run after power reset

MSPM0L1305: MSPM0L1305: Flashed the code does not run after power reset

santhosh prem
Intellectual 340 points
Part Number: MSPM0L1305
Other Parts Discussed in Thread: UNIFLASH

Tool/software:

 

Hi Team,

After flashing the code into the controller, it is not waking up. I removed and connected my debugger, and only then did the controller start running.

The TI team suggested that NRST should have a pull-up resistor of 47K. I have already added a 47K resistor, but despite this, I am still unable to wake up the microcontroller. This is urgent. Could anyone please help me with this ASAP.

  • 0
    TI__Mastermind 26555 points

    Hi santhosh,

    I checked your previous thread, I suppose the ervironment is remained unchanged. Please let me aware if there anything changed.

    It seems you enter a new problem, which is different with the previous thread.

    Currently it requires your manually reset to start the code, I suppose there should be some debugger behavior, sometimes it will halt the code running when it download firmware to device. There always could set the debugger to send a hardware reset to device to let mcu run the code.

    B.R.

    Sal

  • 0 in reply to Sal Ye
    Intellectual 340 points

    Hi Sal,

    Thank you so much, Any solution for this 

    We are expecting when the power-up code should run without a hardware reset 

    Can you please help me with this

  • 0 in reply to santhosh prem
    TI__Mastermind 26555 points

    Hi Santhosh,

    How you download the code to the device?

    Using CCS with LOAD botton? Or, using UNIFLASH?

    Could you share me more details? I used to play with CCS and Uniflash, it could set some debugger behavior and do not need user's manually reset the device.

    By the way, could you share you VCC/VCORE/VSS/NRST partial schematic to me? I want to double check it.

    B.R.

    Sal