MSPM0C1104: why flash hex file can't powon

bill.liao

Part Number: MSPM0C1104
Other Parts Discussed in Thread: UNIFLASH,

Tool/software:

hi, experts:

I use CCS Theia 1.3.1 and enable hex output, choose Intel hex, then use UniFlash 8.7.0 to flash the hex into the evb, but found it can't power on, can you help to find the cause? Thanks.

Bill

over 2 years ago

0 Xiaodong LI over 2 years ago

TI__Mastermind 26335 points

Hi Bill

Could you please comment what evb you used? is it LP-MSPM0C1104: https://www.ti.com/tool/LP-MSPM0C1104 or customized board?

>> but found it can't power on

if you reconnected this board with CCS again, May I know if you can connect, download and debug code using this board?

Thanks

0 bill.liao over 2 years ago in reply to Xiaodong LI

Intellectual 335 points

Hi，Xiaodong:

Yes. it is LP-MSPM0C1104, after download the hex, I can't download or debug, only can use CCS to do the factory reset, then it can be download again.

0 Xiaodong LI over 2 years ago in reply to bill.liao

TI__Mastermind 26335 points

Hi Bill

So, what is the code function? Is this code related with flash operation?

Thanks

0 bill.liao over 2 years ago in reply to Xiaodong LI

Intellectual 335 points

hi, Xiaodong:

NO, just simple test of TIMA0, attached is the project along with the hex file.test_tima0.rar

Arm-based microcontrollers

Arm-based microcontrollers forum

MSPM0C1104: why flash hex file can't powon