Original question:
TMS570LC4357 Tool/software:
Hello ti e2e , there is problem after many times building the the code path not "program make path not found " is comming
the program is building propory but as we do progress in our code and building , it gives error like this , thanks a lot all of you , thanks in advance. i am using 12.0.0 version of ccs
Hi Ashutosh,
Can you please refer below thread and try the settings they mentioned?
If it doesn't help, then can you please share your project for verification at my end?
--
Thanks & regards,
Jagadish.
Hi Ashutosh,
I compared your project properties with my existing project and i found the difference here:
The above highlighted setting is not set properly and which is causing the PATH error.
And i also modified few more other settings and i also included some more paths and finally i was able to build your project successfully.
I am sending the working project over the private message, please download and use it.
--
Thanks & regards,
Jagadish.
