AM2634: Clarification on Device Naming Convention of AM2634

Bivin George

Expert 1057 points

Part Number: AM2634

Tool/software:

Based on Device Naming Convention, it is shown as below.

What is the difference between option F & M.

In website as well as datasheet, part with feature F is not listed, please explain.

Regards

Bivin

over 2 years ago

0 Ralph Jacobi over 2 years ago

TI__Guru*** 135355 points

Hello Bivin,

Bivin George said:
What is the difference between option F & M.

The difference is standard vs enhanced analog:

Best Regards,

Ralph Jacobi

0 Bivin George over 2 years ago in reply to Ralph Jacobi

Expert 1057 points

Hi Ralph

In listed options, it was mentioned pre-integrated stacks enabled, is this a typo ?

Does this mean option F is not available ?

Can you share the link for above reference shared ?

Regards

Bivin

+1 Ralph Jacobi over 2 years ago in reply to Bivin George

TI__Guru*** 135355 points

Hello Bivin,

Bivin George said:
In listed options, it was mentioned pre-integrated stacks enabled, is this a typo ?

No that is correct. The pre-integrated stacks refer to Ethernet related stacks and so no bearing on Analog feature set.

Bivin George said:
Does this mean option F is not available ?

It's possible we don't have an orderable part number on TI.com today for it but if that is the exact feature set you require, I will inquire about when we would offer an option F version.

Bivin George said:
Can you share the link for above reference shared ?

That footnote comes from Section 5 Device Comparison of the device datasheet: https://www.ti.com/lit/gpn/am2634

Best Regards,

Ralph Jacobi

Arm-based microcontrollers

Arm-based microcontrollers forum

AM2634: Clarification on Device Naming Convention of AM2634