• State
  • Locked Locked
  • Replies 4 replies
  • Subscribers 31 subscribers
  • Views 199 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

MSPM0G3507: Memory write failed error in CCS THEIA

Krushna Thete
Intellectual 360 points
Part Number: MSPM0G3507
Other Parts Discussed in Thread: SYSCONFIG

Tool/software:

Hello,

I am encountering an issue while trying to load a file in CCS Theia. The error message I receive is:

Here are the steps I have already tried to resolve the issue:

  1. Checked and configured the erase settings in Project Properties > Debug > MSPM0 Flash Settings.
  2. Performed a factory reset on the controller.
  3. Ensured that I am using the latest versions of CCS Theia, Sysconfig, and the MSPM0 SDK.

Could anyone please provide further guidance to resolve the problem

  • 0
    TI__Mastermind 39575 points

    Hi,

    Let me check with colleague and help you on this case. 

    Best regards,

    Cash Hao

  • 0
    TI__Genius 15690 points

    Hi Krushna,

    Have you static write protected any region on the device?

    If so, I believe you need to apply a factory reset to the device, as this will also erase the region that configures static write protection.

  • 0 in reply to Dylan OBrien
    Intellectual 360 points

    Hi Dylan,

    I have already tried factory reset to the device & I am directly using <bsl_uart_flash_interface> example from the sdk no changes made, but still the same error persists.

    Thanks,

    Krushna

  • 0 in reply to Krushna Thete
    TI__Genius 15690 points

    Hi Krushna,

    When you attempt to factory reset the device, what steps are you using?

    The correct steps are to right click your target configuration, click "start projectless debug" to connect to your device. Then go to the scripts tab and hit the factory reset option. 

    My assumption is that you are taking different steps when performing the reset.