Hello,
I am developing the bus safety ECC on a AM263P4 device, I started the development based on the example given in mcu_plus_sdk_am263px_11_00_00_19\examples\sdl\ecc_bus_safety
I tried to match the SDL_ECC_BUS_SAFETY_.... definitions listed in sdl_ecc_bus_safety_soc.h with the information given in Chapter 3.11 of SPRUJ55D (Figure 3-1, Figure 3-2, Table 3.4). Doing this, I was not able to find all the "bus safety nodes" of the code in the documentation.
Therefore: could you provide documentation about how to correlate the "bus safety nodes" defined in sdl_ecc_bus_safety_soc.h to the documentation in SPRUJ55D?
Attached you find the results of my analysis. The fields i was not able to find are marked yellow. AM263Px Bus ECC Nodes.xlsx
Thanks,
Flurin
