• State Resolved
  • Locked Locked
  • Replies 6 replies
  • Subscribers 31 subscribers
  • Views 637 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Blackhawk USB100V2 CCS 6.0.1: Error Connecting Target

Aniketh Chepuri
Intellectual 530 points
Other Parts Discussed in Thread: TMS570LS20216

Hello, 

I am trying to flash through a Blackhawk USB100v2 to TMS570LS20216. It shows an error connecting to the target.

What should be the Emulator configuration??

In the emulator configuration in CCS 6.0.1 the Blackhawk USB100v2 is not shown, Should change the version of CCS ?? Kindly Suggest me.

Best Regards,

Aniketh Chepuri.

  • 0
    Guru 192875 points
    Hi Aniketh,

    First of all the above device belongs to Hercules Family. Secondly, you can select the generic TI XDS100v2 emulator from the list.

    Regards,
    Gautam
  • 0 in reply to Gautam Iyer
    Intellectual 530 points
    Hello Gautam,

    I have selected the TIXDS100v2 but shows an "error - 242" connecting the target. Should I make any settings ??

    Thank you,
  • 0 in reply to Gautam Iyer
    Intellectual 530 points
    I Followed the link but I could not find the problem. Still the error shows. Could you kindly suggest me ??
  • 0 in reply to Aniketh Chepuri
    TI__Guru 57255 points
    I'm moving this thread to the Hercules support forum.
  • 0 in reply to Aniketh Chepuri
    Intellectual 530 points

    Hello,

    I had made new target configuration settings and tested to communicate with the Emulator still I could not find the Error.

    So I here paste the Status file that has been generated during the test. Could any one kindle suggest me. Thank you.

    -----------------------------------------------------------------------------------------------------

    [Start: Texas Instruments XDS100v2 USB Emulator_0]

    Execute the command:

    %ccs_base%/common/uscif/dbgjtag -f %boarddatafile% -rv -o -F inform,logfile=yes -S pathlength -S integrity

    [Result]


    -----[Print the board config pathname(s)]------------------------------------

    C:\Users\achepuri\AppData\Local\TEXASI~1\
    CCS\ti\0\0\BrdDat\testBoard.dat

    -----[Print the reset-command software log-file]-----------------------------

    This utility has selected a 100- or 510-class product.
    This utility will load the adapter 'jioserdesusb.dll'.
    The library build date was 'May 21 2014'.
    The library build time was '17:19:59'.
    The library package version is '5.1.507.0'.
    The library component version is '35.34.40.0'.
    The controller does not use a programmable FPGA.

    An error occurred while hard opening the controller.

    -----[An error has occurred and this utility has aborted]--------------------

    This error is generated by TI's USCIF driver or utilities.

    The value is '-183' (0xffffff49).
    The title is 'SC_ERR_CTL_CBL_BREAK_FAR'.

    The explanation is:
    The controller has detected a cable break far-from itself.
    The user must connect the cable/pod to the target.

    [End: Texas Instruments XDS100v2 USB Emulator_0]